Hyundai Tucson: Body Side Molding / Door Garnish
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Loosen the mounting nuts, remove the front door garnish (A) and rear door garnish (B).
2.To install, reverse the removal procedure.
• Replace any damaged clips (or pin-type retainers).
Quarter Garnish
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
C Pillar Garnish
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: A/C Pressure Transducer
- Description
The A/C Pressure Transducer (APT) converts the pressure value of high
pressure line into voltage value after measuring it. By converted
voltage value, engine ECU controls the cooling fan by operating it high
speed or low speed. Engine ECU stops the operation of the compressor ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Fuel Sender
- Removal
1.Remove the fuel pump.(Refer to Fuel Delivery System - "Fuel Pump")
2.Disconnect the fuel sender connector (A).
3.Release the fixing hook (A) and then remove fuel sender (B) in the arrow direction.
- Installation
1.Install in the reverse order of removal. ...
