Hyundai Tucson (NX4) 2022-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Quarter Garnish

Hyundai Tucson: Body Side Molding / Quarter Garnish

- Replacement

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• Put on gloves to prevent hand injuries.

1.Using a screwdriver or remover, remove the quarter garnish (A).

2.To install, reverse removal procedure.

• Replace any damaged clips (or pin-type retainers).

Fender Garnish

- Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Put on gloves to prevent h ...

Door Garnish

- Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Put on gloves to prevent h ...

Other information:

Hyundai Tucson (NX4) 2022-2026 Service Manual: Troubleshooting
- Troubleshooting SymptomSuspect area Engine will not start or hard to startVapor hose damaged or disconnected Engine struggles to startMalfunction of the Purge Control Solenoid Valve Rough idle or engine stallsVapor hose damaged or disconnected Malfunction of the PRV (Pressure Regulating Val ...

Hyundai Tucson (NX4) 2022-2026 Service Manual: Water Jacket Insert
- Removal and installation • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.(Refer to General Information - "Lift and Support Points") 1.Remove the cylinder ...