
1. Crash pad center panel
• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
• Put on gloves to protect your hands.
• Take care not to bend or scratch the trim and panels.
1.Remove the floor console assembly.(Refer to Floor Console - "Floor Console Assembly")
2.Remove the crash pad under cover.(Refer to Crash Pad - "Crash Pad Under Cover")
3.Remove the glove box.(Refer to Crash Pad - "Glove Box")
4.Remove the front monitor.(Refer to Body Electrical System - "Front Monitor")
5.Remove the crash pad lower panel.(Refer to Crash Pad - "Crash Pad Lower Panel")
6.Remove the crash pad garnish[RH].(Refer to Crash Pad - "Crash Pad Garnish")
7.Loosen the mounting screws, bolts and nuts, remove the crash pad center panel (A).

8.Disconnect the connectors (A).

9.Disconnect the in-car sensor connector (A) and hoses (B).

10.To install, reverse removal procedure.
• Make sure the connector are connected in properly.
• Replace any damaged clips.
Crash Pad Under Cover
Main Crash Pad AssemblyHyundai Tucson (NX4) 2022-2025 Service Manual: General Information
- General Service Information
Protection of the VehicleAlways be sure to cover fenders, seats, and floor areas prior to beginning work.
• The support rod must be inserted into the hole near the edge of
the hood whenever you inspect the engine compartment to prevent the hood ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Rear Coil Spring
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister).(Refer to General Information - "Lift and Support
Points")
1.Loosen the rear wheel nuts slightly.Raise the v ...