Hyundai Tucson: Liftgate / Liftgate Back Panel Molding
1. Liftgate back panel molding
• Put on gloves to prevent hand injuries.
• Take care not to scratch the liftgate and body surface.
1.Using a screwdriver or remover, remove the liftgate back panel molding (A).
2.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
Liftgate Weatherstrip
- Replacement
• Do not apply sealant to the body.
1.Remove the liftgate weatherstrip (A).
2.To install, reverse removal procedure.
• When installing ...
Fuel Filler Door
Components and Components Location
- Component Location
1. Fuel filler door
Repair procedures
- Replacement
[Fuel filler door cover]
• When removing with a flat-ti ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Oil Seal
- Replacement
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.(Refer to General Information - "Lift and
Support Points")
1.Remove the Automatic Transaxle A ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Delivery Pipe
- Removal
Low Pressure Delivery Pipe
1.Release the residual pressure in fuel line.(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.Turn the ignition switch OFF and disconnect the battery negative (-) cable.
3.Disconnect the injector connector (A).
4.Disconnec t ...
