Hyundai Tucson: Immobilizer System / Antenna Coil
1.Disconnect the negative (-) battery terminal.
2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")
3.Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
1.Install the coil antenna and connect the 6P connector.
2.Install the crash pad lower panel.
3.Connect the negative (-) battery terminal.
Immobilizer Control Unit
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the heater control unit.(Refer to Heating,Ventilation And Air Conditioning - "Heater Control Unit")
3.Loosen the mounting bolt ...
Auto Lighting Control System
Description and Operation
- Description
It's a system that uses illumination sensor to automatically turn ON
the tail lamp and head lamp based on the change in surrounding
environment's illumi ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Intake Actuator
- Description
The intake actuator is located at the blower unit. It regulates the
intake door by a signal from the control unit. Pressing the intake
selection switch will shift between recirculation and fresh air modes.
- Components
1. Intake actuator
- Inspection
1.Turn the i ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Upper Arm
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister).(Refer to General Information - "Lift and Support
Points")
1.Loosen the rear wheel nuts slightly.Raise the v ...
