| Symptom | Possible cause | Countermeasure |
| Wind noise around the door | Arise the gap on weatherstrip | Replace weatherstrip |
| Water leaks from panorama sunroof | Miss install of panorama sunroof frame weather strip and deforming | Replace |
| seal breakage | Fill with sealant | |
| Wind noise on Panorama Sunroof | Deflector deformation and deviation | Replace or Remounting |
| Noise while panorama sunroof is working (noise when opening or closing) | Accumulation on the guide rail or rear rail | Clean guide rail/rear rail and apply grease |
| Tilt lever shoe excessive wear and breakage | Replace tilt lever shoe | |
| Panorama Sunroof malfunction (Motor work, sunroof move partially or does not move | Accumulation on the guide rail or rear rail | 1. Clean guide rail/rear rail and apply grease |
| 2. Adjustment or replacement | ||
| Poor engagement drive cable and motor pinion. | Adjustment or replacement | |
| Sunroof operating resistance or interference (with cable, weather strip) increased. | Adjustment or replacement | |
| Motor initial value (position value) loss | Motor Initialization | |
| motor noise | Poor engagement drive cable and motor pinion. | NNN |
| Motor pinion gear worn out or breakage | Motor Replacement | |
| Drive cable worn out or breakage | Replacement | |
| Door glass inoperative | Incorrect window glass installation | Repositioning |
| Motor failure or regulator breakage/deformationDamaged or faulty motor and regulator | Adjustment or replacement | |
| Door does not open or close completely | Door installation incorrect or striker/latch misalignment | Adjust position |
| Breakage, deformation, incorrect installation on door handle and latch. Deformation of checker | Adjustment or replacement | |
| Not enough grease on door hinge and checker | Apply grease | |
| Hood does not open or close completely | Striker and latch are not properly aligned. | Adjustment |
| Hood installation incorrect | Adjustment | |
| Incorrect hood bumper height | Adjustment | |
| Water leak on windshield or rear window | Defective seal | Apply sealant |
| Defective flange | Adjustment | |
| Wiper blade wiping/vibration noise | Glass surface contamination | Remove the foreign matters and water-repellent coating using a clean wet towel. |
| Wiper blade contamination | Clean wiper blade using a clean wet towel. | |
| Improper wiper arm angle | Check wiper arm angle specification and adjust. | |
| Wiper blade worn out | Wiper blade replacement. | |
| Wiper blade failure | Check if “tick� sound. | |
| Wiper blade clearance | Press the left and right sides of the blade using tools. |
SpecificationsHyundai Tucson (NX4) 2022-2026 Service Manual: Purge Control Solenoid Valve (PCSV)
- Description
Purge Control Solenoid Valve (PCSV) is a solenoid valve and is
installed on the surge tank and controls the passage between the
canister and the intake manifold.The evaporative gases gathered in the
canister are delivered to the intake manifold when the PCSV is open by
ECM c ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Wheel Alignment and Tire
Balance
The wheels on your vehicle were
aligned and balanced carefully at
the factory, and you may not need
to have your wheels aligned again.
If you notice unusual tire wear or
your vehicle pulling to one side, the
alignment may need to be adjusted.
If you notice your vehicle vibrating
when ...