The trip computer displays information related to driving.
Information
Some driving information stored in the trip computer resets if the battery is disconnected.
Trip modes
.png)
.png)
.png)
To change the trip mode, toggle the ˄,˅ switch on the steering wheel.
Resetting average fuel economy
Information
If equipped with a 10.25-inch instrument cluster, the fuel economy appears in the center bottom of the cluster.
Drive Info
.png)
Trip distance 1, average fuel economy 2, and total driving time 3 appear.
The information is combined for each ignition cycle. However, when the engine has been OFF for 3 minutes or longer the Drive Info screen is reset. To reset manually, press the OK button on the steering wheel for more than 1 second when "Drive Info" appears.
Since Refueling
.png)
After the vehicle has been refueled, the trip distance 1, average fuel economy 2, and total driving time 3 appear.
To reset manually, press the OK button on the steering wheel for more than 1 second when "Since Refueling" appears.
Accumulated Info
.png)
Accumulated trip distance 1, average fuel economy 2, and total driving time 3 appear.
The information is accumulated starting from the last reset.
To reset manually, press the OK button on the steering wheel for more than 1 second when "Accumulated Info“ appears.
Auto stop
.png)
Displays the elapsed time of engine stop by the Idle Stop and Go system.
For more information, refer to the “Idle Stop and Go (ISG)” section in Chapter 6.
Digital speedometer
.png)
Displays the speed of the vehicle.
Trip Computer (Type A)
Infotainment system vehicle settings. Setting Your VehicleHyundai Tucson (NX4) 2022-2026 Service Manual: Side Airbag (SAB) Module
- Description
The Side Airbags (SAB) are installed inside the front seat and protects
the driver and passenger from danger when side crash occurs. The SRSCM
determines deployment of side airbag by using Side Impact Sensor (SIS)
signal.
• Never attempt to measure the cir ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Inspection
Tolerance Calibration Outline
• SVM calibration tool is required to perform tolerance calibration as shown below.
• Refer to the information below to purchase the SVM calibration tool.
– Tool Name : GDS SVM HYUNDAI (SVM-100)
– Representative purc ...