
1. Sunroof assembly
• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on glove to protect your hands.
1.Remove the roof trim.(Refer to Roof Trim - "Roof Trim Assembly")
2.Remove the sunroof glass.(Refer to Sunroof - "Sunroof Glass")
3.Loosen the mounting screws and remove the sunroof motor (A).

4.After loosening the mounting bolts, then remove the assist handle bracket (A).

5.Disconnect the drain tubes (B).
6.After loosening the mounding nuts and bolts, remove the sunroof assembly (A).
Tightening torque : Bolt : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)Nut : 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

7.To install, reverse the removal procedure.
• Make sure to initialize the motor.
Sunroof Deflector
Sunroof SunshadeHyundai Tucson (NX4) 2022-2026 Owner's Manual: System Maintenance
Air Conditioning Performance and
Maintenance at Your HYUNDAI
Dealer
If the amount of refrigerant is too low
or too high, the performance of the air
conditioning is reduced. Have the system
be inspected by an authorized HYUNDAI
dealer.
NOTICE
The refrigerant system should only
be ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Washer Switch
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the clock spring.(Refer to Restraint - "Driver Airbag(DAB) and Clock Spring")
3.Disconnect multifunction switch assembly connector (A).
4.Remove the multifunction switch assembly (B) after loosening the clamp (A).Tightening ...