
1. Crash pad air vent [LH]
2. Crash pad air vent [RH]
[LH]
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Disconnect the negative (-) battery terminal.
2.Remove the instrument cluster.(Refer to Body Electrical System - "Instrument Cluster")
3.Remove the front monitor.(Refer to Body Electrical System - "Front Monitor")
4.Loosen the mounting screw, remove the crash pad air vent[LH] (A).

5.Install in the reverse order of removal.
• Replace any damaged clips (or pin - type retainers).
[RH]
• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Disconnect the negative (-) battery terminal.
2.Remove the crash pad side cover[RH].(Refer to Crash Pad - "Crash Pad Side Cover")
3.Remove the front monitor.(Refer to Body Electrical System - "Front Monitor")
4.Loosen the mounting screw, remove the crash pad air vent[RH] (A).

5.Install in the reverse order of removal.
• Replace any damaged clips (or pin - type retainers).
Steering Column Shroud Panel
Crash Pad Side CoverHyundai Tucson (NX4) 2022-2026 Owner's Manual: Rear Cross-Traffic Collision-Avoidance Assist (RCCA)
Rear Cross-Traffic Collision-Avoidance
Assist uses the rear corner radars to help
detect vehicles approaching from the left
or right while your vehicle is reversing,
and to warn you that a collision is
imminent with a warning message and
an audible warning. Braking may also be
assisted ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Special Service Tools
- Special Service Tools
TypeTools(Number and name)IllustrationUse
[A]Oil seal installer 09473-D3600
Used for installing the transfer case oil seal (Driveshaft side)(Used with the handle)
Handle09231-H1100
Used for installing the transfer case oil seal(Used with the oil seal installer)
TypeT ...