Hyundai Tucson (NX4) 2022-2025 Owner's Manual / Driver Assistance System / Smart Cruise Control (SCC)

Hyundai Tucson: Driver Assistance System / Smart Cruise Control (SCC)

Basic function

Smart Cruise Control uses the front view camera and front radar to help detect a vehicle ahead and maintain the desired speed and distance between your vehicle and the vehicle ahead.

Overtake Assist Control

While Smart Cruise Control is operating, if the function judges you are attempting to overtake a vehicle in front, Smart Cruise Control accelerates your vehicle to assist you with this maneuver.

WARNING

Always monitor your vehicle speed and the distance to vehicles ahead on the road. Smart Cruise Control is not a substitute for safe driving practices, but a supplemental function only.

Information

Refer to the "Driver Assistance Sensors" section in this chapter for the location and the general precautions of front view camera and front radar.

Cruise Control Operation

To set cruise speed 1. Accelerate to the desired speed, which must be more than 20 mph (30 km/h). 2. Press the Driving Assist () button at the desired speed. The set speed and Cruise () ...

Smart Cruise Control Settings

Based on Drive Mode Smart Cruise Control accelerates differently based on the drive mode selected from Drive Mode Integrated Control system. Information For more information, refer to th ...

Other information:

Hyundai Tucson (NX4) 2022-2025 Service Manual: Power Door Lock Actuators
- Inspection Front Door Lock Module Inspection 1.Remove the front door trim.(Refer to Body - "Front Door Trim") 2.Disconnect the connectors from the actuator. 3.Check actuator operation by connecting power and ground according to the table.PinDescription DriverPanssenger 1-M2 2-M3 3COM- ...

Hyundai Tucson (NX4) 2022-2025 Service Manual: Front View Camera Unit
- Circuit Diagram - Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the inside rear view mirror cover (A) 3.Remove the front view camera cover (A). 4.Disconnect the front view camera connector (A). 5.Separate the fixed points (A) of coupler and remove the fr ...