• Never attempt to measure the circuit resistance of the Seat Belt Pretensioner (BPT) even if you are using the specified tester. If the circuit resistance is measured with a tester, the pretensioner will be ignited accidentally. This will result in serious personal injury.

1. Front Seat Belt Pretensioner (BPT)
1.Disconnect the battery negative terminal.
• After disconnecting the cables, wait at least 3 minutes.
2.Remove the front anchor seat belt (A).

3.Remove the center pillar upper trim.(Refer to Body - "Center Pillar Trim")
4.Disconnect the seat belt pretensioner connector (A) and then remove the seat belt pretensioner.

5.After loosening the mounting bolt, then remove the front seat belt lower anchor (A).
Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

6.Remove the seat belt pretensioner (A) after loosening the mouning bolts.
Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

1.Install in the reverse order of removal.
2.After installing the airbag module, confirm proper system operation.
• Switch ON the ignition. The SRS indicator light should turn on for about three-six seconds and then off.
Airbag Module DisposalHyundai Tucson (NX4) 2022-2026 Owner's Manual: Fuel Requirements
Gasoline Engine
Unleaded
Your new vehicle is designed to perform
optimally with unleaded fuel having
an octane number ((R+M)/2) of 87
(Research Octane Number 91) or higher.
Your new vehicle is designed to obtain
maximum performance with UNLEADED
FUEL, as well as minimize exhaust
emiss ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Auto defoging sensor
- Description
The auto defogging sensor is installed on the front window glass. The
sensor judges and sends signal if moisture occurs to blow out wind for
defogging. The air conditioner control module receives signal from the
sensor and restrains moisture and eliminate defog by controlling ...