• Never attempt to measure the circuit resistance of the Seat Belt Pretensioner (BPT) even if you are using the specified tester. If the circuit resistance is measured with a tester, the pretensioner will be ignited accidentally. This will result in serious personal injury.
1. Front Seat Belt Pretensioner (BPT)
1.Disconnect the battery negative terminal.
• After disconnecting the cables, wait at least 3 minutes.
2.Remove the front anchor seat belt (A).
3.Remove the center pillar upper trim.(Refer to Body - "Center Pillar Trim")
4.Disconnect the seat belt pretensioner connector (A) and then remove the seat belt pretensioner.
5.After loosening the mounting bolt, then remove the front seat belt lower anchor (A).
Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)
6.Remove the seat belt pretensioner (A) after loosening the mouning bolts.
Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)
1.Install in the reverse order of removal.
2.After installing the airbag module, confirm proper system operation.
• Switch ON the ignition. The SRS indicator light should turn on for about three-six seconds and then off.
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Collision-avoidance assist (while
driving)
To warn you of a potential collision, the
warning light on the side view mirror may
blink, a warning message may appear on
the instrument cluster, and an audible
warning may sound.
Blind-Spot Collision-Avoidance Assist
operates when your vehicle speed is
about 40-120 mph (60-200 ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Cylinder Head Cover
- Removal
• Use fender covers to avoid damaging painted surfaces.
• To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
• Mark all wiring and hoses to avoid misconnection.
1.Disconnect the battery negati ...