Hyundai Tucson (NX4) 2022-2025 Service Manual / Body Electrical System / Lighting System / Specifications
Hyundai Tucson: Lighting System / Specifications
| Items | Bulb Type | Bulb Wattage (W) | ||
| Front | Head lamp (STD) | Low | 9005HL+ | 60 |
| High | 9005HL+ | 60 | ||
| Head lamp (Option) | Low | LED | LED | |
| High | LED | LED | ||
| Turn signal lamp (STD) | PY21W | 21 | ||
| Turn signal lamp (Option) | LED | LED | ||
| Position lamp | LED | LED | ||
| Daytime Running Lamp (DRL) | LED | LED | ||
| Door mirror turn signal lamp | LED | LED | ||
| Rear | High mounted stop lamp | LED | LED | |
| Rear combination lamp (STD) | Stop/ Tail lamp | PY21/5W | 21/5 | |
| Tail lamp | PY21/5W | 21/5 | ||
| Rear combination lamp (Option) | Stop | LED | LED | |
| Tail lamp | LED | LED | ||
| Turn signal lamp | PY21W | 21 | ||
| Back up lamp | W5W | 5 | ||
| License plate lamp | W5W | 5 | ||
| Cargo lamp | FESTOON | 10 | ||
| Map lamp (STD) | W10W | STD : 10 | ||
| Map lamp (Option) | LED | LED | ||
| Room lamp | FESTOON | 10 | ||
| Vanity lamp | FESTOON | 5 | ||
| Rear personal lamp | LED | LED | ||
Troubleshooting
- Troubleshooting
SymptomPossible causeRemedy
One lamp does not light(all exterior)Bulb burned outReplace bulb
Socket, wiring or ground faultyRepair if necessary
Head lamps do not lightBulb burn ...
Head Lamps
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the front bumper assembly.(Refer to Body - "Front Bumper Assembly")
3.Disconnect the head lamp connector (A).
4.Loosen the ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Automatic Transmission
A: Shift lever, B: Shift release button,
C: Manual shift mode
Depress the brake pedal and
press the
Shift release button while moving the
shift lever.
Press the Shift release button
while
moving the shift lever.
The shift lever can freely
operate.
Button type
Depress the br ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Side Sill Molding
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Loosen the mounting screws, remove the side seal molding (A).
2.To install, rev ...
© 2023-2025 Copyright www.htucson4.com
