Hyundai Tucson: Climate Control Additional Features / Recirculating Air when Washer Fluid is Used
Recirculation mode automatically activates to reduce the scent of the washer fluid entering the cabin when the windshield washer is used.
When it is shifted to the recirculation mode, the unpleasant scent may flow into the vehicle.
However, in cold weather to prevent the windshield from fogging up, the recirculation mode may not be selected.
Turning Activate upon Washer Fluid Use ON or OFF
Climate control system
To turn the Activate upon Washer Fluid
Use feature on or off, select Floor-level
(.png)
) mode, and then press the air
intake control (.png)
) button four times
within two seconds while pressing the
A/C button.
When Activate upon Washer Fluid Use ON is turned on, the air intake control button indicator blinks 6 times. When turned off, the indicator blinks 3 times.
Infotainment system
Activate upon Washer Fluid Use can be turned on and off by selecting Setup > Vehicle > Climate > Recirculate Air > Activate upon Washer Fluid Use from the Settings menu.
Auto Defogging System
on Models with Automatic
Temperature Control
Auto defogging reduces the likelihood of
fogging up the inside of the windshield
by sensing moisture on the inside of the
windshield.
The auto defogging system operates
when the heater or a ...
Sunroof Inside Air Recirculation. Auto Dehumidify
Sunroof Inside Air Recirculation
(if equipped)
When the sunroof is opened, the fresh
mode is automatically selected. If you
press the air intake control button,
the recirculation mode is sele ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Door Inside Handle
- Replacement
1.Disconnect the negative ( - ) battery terminal.
2.Remove the rear door trim.(Refer to Rear Door - "Rear Door Trim")
3.Loosen the mounting screws and remove the rear door inside handle (A).
4.To install, reverse removal procedure.
• Make sure the door lo ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Electric EGR Control Valve
- Description
The Electric EGR Control Valve is installed in between the EGR cooler
and the exhaust line and is a solenoid valve. This valve controls EGR
(Exhaust Gas Recirculation) amount by the ECM's duty control signal
depending on engine load and the need of intake air.The Exhaust Gas
...
