Hyundai Tucson: Rear Suspension System / Rear Upper Arm
• When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister).(Refer to General Information - "Lift and Support Points")
1.Loosen the rear wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.
2.Remove the rear wheel and tire.(Refer to Suspension System - "Wheel")
3.Remove the rear upper arm (A) after loosening the mounting bolts and nuts.
Tightening torque : 137.2 - 156.9 N.m (14.0 - 16.0 kgf.m, 101.2 - 115.7 lb-ft)
• Set up the transmission jack under the lower arm in order to remove it in no-load condition.
1.Check the bushing for wear and deterioration.
2.Check the rear upper arm or damage and deformation.
3.Check for all bolts and nut.
1.To install, reverse the removal procedures.
2.Check the alignment.(Refer to Suspension System - "Alingment")
Rear Shock Absorber
- Components
1. Lock nut2. Insulator assembly 3. Dust cover 4. Rear shock absorber
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lo ...
Rear Lower Arm
...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Pressure Sensor
- Description
The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an
oil pressure. And then it presses a multiple disk clutch and transfers
the generated torque into rear wheels. Its torque value varies according
to a pressure status. • Component location
- Circuit Di ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Adjustment
Inspect Glass Alignment
1.Inspect the step height between the roof panel (A) and the glass weatherstrip (B) and then adjust it if necessary.Alignment
adjustment Standard value [mm(in.)](1) Front edge : -1 ~ 0 mm (-0.04 ~ 0
in.)(2) Rear edge : 0 ~ 1 mm (0 ~ 0.04 in.)(3) Side edg ...
