Hyundai Tucson: Driver Assistance System / Rear Cross-Traffic Collision-Avoidance Assist (RCCA)
Rear Cross-Traffic Collision-Avoidance Assist uses the rear corner radars to help detect vehicles approaching from the left or right while your vehicle is reversing, and to warn you that a collision is imminent with a warning message and an audible warning. Braking may also be assisted to avoid a collision.
.png)
A: Rear Cross-Traffic Collision Warning operating
range,
B: Rear Cross-Traffic Collision-Avoidance Assist
operating range
The warning timing may differ depending on the speed of the detected vehicle.
Information
Refer to the "Driver Assistance Sensors" section in this chapter for the location and the general precautions of rear corner radar.
- Rear Cross-Traffic Collision- Avoidance Assist Settings
- Rear Cross-Traffic Collision- Avoidance Assist Operation
- Rear Cross-Traffic Collision- Avoidance Assist Malfunction and Limitations
Rear Cross-Traffic Collision
Warning Malfunction and
Limitations
Rear Cross-Traffic Collision Warning
malfunction
When the Rear Cross-Traffic Collision
Warning is not working properly, the
"Check Rear Cross-Traffic Safety system"
warning message may appe ...
Rear Cross-Traffic Collision-
Avoidance Assist Settings
Rear Cross-Traffic Safety
With the ignition switch ON, go to User
Settings > Driver Assistance > Parking
Safety > Rear Cross-Traffic Safety (for
cluster type) or Setup > Vehicle & ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Blind-Spot Collision Warning
Malfunction and Limitations
Blind-Spot Collision Warning
malfunction
When the Blind-Spot Collision Warning is
not working properly, the "Check Blind-
Spot Safety system" warning message
may appear, and the
warning light
may illuminate on the instrument
cluster. Have the vehicle inspected by an
authorized HYU ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Glass
- Removal
• In order to remove rear glass, use tools as follows shown in the picture.[Tooling Diagram]
â‘ Square wireâ‘¡ Insert type wire grip[Tools Assembly Diagram]
• Tighten square wire ①inserting it in the hole of Insert type wire grip ②
1.Remove the mov ...
