Hyundai Tucson: Rear Cross-Traffic Collision-Avoidance Assist (RCCA) / Rear Cross-Traffic Collision- Avoidance Assist Settings
Rear Cross-Traffic Safety
.png)
With the ignition switch ON, go to User Settings > Driver Assistance > Parking Safety > Rear Cross-Traffic Safety (for cluster type) or Setup > Vehicle > Driver Assistance > Parking Safety > Rear Cross-Traffic Safety (for infotainment system type) from the Settings menu to turn Rear Cross-Traffic Collision- Avoidance Assist on and off.
WARNING
When the engine is restarted, the Rear Cross-Traffic Collision-Avoidance Assist turns on. If Off is selected after the engine is restarted, Rear Cross-Traffic Collision-Avoidance Assist does not function until the next time your vehicle is started.
Information
Settings for Rear Cross-Traffic Safety include Rear Cross-Traffic Collision Warning and Rear Cross-Traffic Collision- Avoidance Assist.
Information
You can change the Warning Timing and Warning Volume settings for Rear Cross- Traffic Collision-Avoidance Assist from the Settings menu. For more information, refer to the "Driver Assistance System Settings" section in this chapter.
Rear Cross-Traffic Collision-Avoidance Assist (RCCA)
Rear Cross-Traffic Collision-Avoidance
Assist uses the rear corner radars to help
detect vehicles approaching from the left
or right while your vehicle is reversing,
and to warn you that a col ...
Rear Cross-Traffic Collision-
Avoidance Assist Operation
Rear Cross-Traffic Collision-Avoidance
Assist may warn and control your vehicle
depending on the collision risk level.
Collision Warning
To warn you of an approaching vehicle
from the rear l ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Refrigerant Line
- Components
1. Suction & Liquid Pipe Assembly
- Replacement
1.If a compressor is available, the air conditioner is operated for a
few minutes in the engine idle state and then the engine is stopped.
2.Disconnect the negative (-) battery terminal.
3.Recover the refrigerant wi ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Normal Maintenance Schedule
I : Inspect and if necessary, adjust, correct, clean or replace.
R : Replace or change.
*1 : Requires <API SN PLUS (or above) Full synthetic> grade engine oil. If a
lower grade engine oil (mineral type, semi-synthetic, lower
grade spec, etc.) is used, replace the engine oil and engine ...
