Hyundai Tucson: Power Liftgate Module / PTG Spindle
1.Disconnect the negative (-) battery terminal.
2.Remove the rear pillar trim.(Refer to Body (Interior and Exterior) - Interior Trim - Rear Pillar Trim)
3.Disconnect the PTG spindle connector (A).
4.Using a flat-tip screwdriver, remove the mounting clip (A).
5.Remove the spindle assembly after loosening mounting bolts.
• Take care not to be closed the lift gate, when removing the lift.
1.Install the PTG spindle assembly.
Tightening torque : 6.9 - 10.8 Nm (0.7 - 1.1 kgf.m, 5.0 - 7.9 lbf.ft)
2.Connect the PTG spindle connector.
3.Install the rear pillar trim.
4.Install the luggage side trim.
5.Connect the negative (-) battery terminal.
Power Liftgate Latch
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the liftlgate trim.(Refer to Body - "Liftgate Trim")
3.Disconnect the latch connector (A).
4. Remove the power liftgate lat ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Multi air mode
When the multi air mode button is
pressed, air flow is directed to the facelevel
and floor-level through the air vents
along the instrument panel for the driver
and passenger. The multi-air mode LED
indicator illuminates. If the multi air
mode button is pressed when the air
volume ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Brake Pad
- Replacement
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.(Refer to General Information - "Lift and
Support Points")
Front Brake Pad
1.Loosen the whee ...
