Hyundai Tucson: Driver Assistance System / Navigation-Based Smart Cruise Control (NSCC)
Navigation-based Smart Cruise Control helps maintain the speed depending on the road conditions when driving on highways by using information from the navigation system while Smart Cruise Control is operating.
Information
- Navigation-based Smart Cruise
Control is available only on controlled
access roads.
- Controlled access roads are roads with limited entrances and exits that allow uninterrupted high speed traffic flow.
.png)
- Additional highways may be available in future navigation system updates.
- Navigation-based Smart Cruise Control does not operate on interchanges or junctions.
Highway Auto Curve Slowdown
If the vehicle speed is high, Highway Auto Curve Slowdown temporarily slows your vehicle in curved sections, based on the curve information in the navigation system.
Highway Auto Speed Change
Highway Auto Speed Change automatically changes Smart Cruise Control set speed based on the speed limit information in the navigation system.
- Navigation-based Smart Cruise Control Settings
- Navigation-based Smart Cruise Control Operation
- Limitations of Navigation-based Smart Cruise Control
Limitations of Smart Cruise Control
Smart Cruise Control may not operate
normally or may operate unexpectedly if:
The sensor or the area near the sensor
is blocked, covered, or damaged.
The temperature near the front view
...
Navigation-based Smart Cruise
Control Settings
Highway Auto Speed Change
With the ignition switch ON, go to
Setup > Vehicle > Driver Assistance >
Driving Convenience > Highway Auto
Speed Change (for infotainment system
type) ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Smart Cruise Control Operation
Operating conditions
Basic function
Smart Cruise Control operates when the
following conditions are met:
The gear is in D (Drive).
Your vehicle speed is within the
operating speed range.
- 5-110 mph (10-180 km/h): When
there is no vehicle in front
- 0-110 mph (0-180 km/h): When ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Mass Air Flow Sensor (MAFS)
- Description
MAFS uses a hot-film type sensing element to measure the mass of intake
air entering the engine, and send the signal to ECM.A large amount of
intake air represents acceleration or high load conditions while a small
amount of intake air represents deceleration or idle. The ECM ...
