Hyundai Tucson (NX4) 2022-2026 Owner's Manual / Seats & Safety System / Seats / Front Seats / Manual seats - Seat adjustments

Hyundai Tucson: Front Seats / Manual seats - Seat adjustments

The front seat can be adjusted by using the levers located underneath the front part of the seat or on the outer side of the seat.

Forward and rearward adjustment

To move the seat forward or rearward:

1. Pull up the seat slide adjustment lever and hold it.

2. Slide the seat to the desired position.

3. Release the lever and make sure the seat is locked in place. Move forward and rearward without using the lever. If the seat moves, it is not locked properly.

Seatback angle

To recline the seatback:

1. Lean forward slightly and lift up the seatback lever.

2. Carefully lean back on the seat and adjust the seatback to the desired position.

3. Release the lever and make sure the seatback is locked in place.

Seat height

To change the height of the seat:

Push down on the lever several times, to lower the seat.
Pull up on the lever several times, to raise the seat.

Front Seats

WARNING To prevent serious injury or death: Never attempt to adjust the seat while the vehicle is moving. The seat could respond with unexpected movement and may cause loss of vehicle co ...

Power seats - Seat adjustment

The front seat can be adjusted by using the control switches located on the outside of the seat cushion. WARNING Never allow children to remain in the vehicle unattended. The power seats are ...

Other information:

Hyundai Tucson (NX4) 2022-2026 Service Manual: Transaxle Control Module (TCM)
- Description • Monitoring the vehicle's operating conditions to determine the optimal gear setting. • Performing a gear change if the current gear setting differs from the identified optimal gear setting. • Determining the need for damper clutch (D/C) activation and engages the clut ...

Hyundai Tucson (NX4) 2022-2026 Service Manual: Center Pillar Trim
- Component Location 1. Center pillar lower trim2.Center pillar upper trim - Replacement [Center pillar lower trim] • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Put on glove ...