Hyundai Tucson Owners & Service Manuals

Hyundai Tucson: Warning and Indicator Lights / Icy road warning light

This indicator light illuminates:

To warn the driver the road may be icy.

When the outside temperature on the temperature gauge is below 40 °F (4 °C), a single chime sounds, both the outside temperature gauge and Icy Road Warning indicator blink several times, and then they remain illuminated.

You can activate or deactivate the Icy Road Warning function from the Settings menu in the instrument cluster or infotainment system.

Select:

  • User Settings > Cluster > Icy Road Warning (for cluster type)
  • Setup > Vehicle > Cluster > Content Selection > Icy Road Warning (for infotainment system type)

Information

  • If the Icy Road warning light appears while driving, avoid speeding, rapid acceleration, sudden braking, or sharp turning.
  • The infotainment system may change after software updates. For more information, refer to the user's manual provided in the infotainment system and the quick reference guide.
    LED headlight warning light
    This warning light illuminates: When the ignition switch is in the ON position. The LED headlight warning light illuminates for about 3 seconds and then goes off. Whenever there is a ...

    Electronic Stability Control (ESC) indicator light. Electronic Stability Control (ESC) OFF indicator light
    Electronic Stability Control (ESC) indicator light This indicator light illuminates: When the ignition switch is in the ON position. The Electronic Stability Control indicator light ill ...

    Other information:

    Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
    - Adjustment Inspect Glass Alignment 1.Inspect the step height between the roof panel (A) and the glass weatherstrip (B) and then adjust it if necessary.Alignment adjustment Standard value [mm(in.)](1) Front edge : -1 ~ 0 mm (-0.04 ~ 0 in.)(2) Rear edge : 0 ~ 1 mm (0 ~ 0.04 in.)(3) Side edg ...

    Hyundai Tucson (NX4) 2022-2026 Service Manual: SBW Control Unit(SCU)
    - Component Location 1. Shift by wire Control Unit (SCU) - Schematic Diagrams PinFunctionPinFunction 1Power21- 2Ground22- 3H-CAN High23- 4H-CAN Low24- 5P-CAN High25- 6P-CAN Low26- 7Position sensor ground27Position sensor signal 1 8-28Position sensor signal 2 9-29P position o ...

    © 2023-2026 Copyright www.htucson4.com