Hyundai Tucson: Hood / Hood Assembly
1. Hood assembly
• Wear gloves to protect hands from injury.
• Be careful not to damage the hood and body.
• When removing and installing the liftgate, an assistant is needed.
1.After loosening the hood hinge (B) mounting bolts, remove the hood assembly (A).
Tightening torque : 21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)
2.To install, reverse removal procedure.
• Make sure the hood locks / unlocks and opens / closes properly.
• Adjust the hood alignment. (Refer yo Hood - Repair procedures")
Repair procedures
- Adjustment
1.After loosening the hinge (A) mounting bolt, adjust the hood (B)
by moving it up and down or from side to side and tighten the bolt.
2.Adjust the hood height by moving the hood o ...
Hood Insulator Pad
- Replacement
• Be careful not to scratch the hood panel.
1.Using a clip remover, remove the clips and then the hood insulator pad (A).
2.To install, reverse removal pro ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Components and Components Location
- Components Location
1. Supplemental Restraint System Control Module (SRSCM)2. Gravity Side Impact Sensor (G-SIS) _ C pillar3. Gravity Side Impact Sensor (G-SIS) _ B pillar4. Front Impact Sensor (FIS) [RH]5. Front Impact Sensor (FIS) [LH]6. Pressure Side Impact Sensor (P-SIS)
...
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Panoramic Sunroof
If your vehicle is equipped with a
sunroof, you can slide or tilt your sunroof
with the sunroof switch located on the
overhead console.
The sunroof can be operated when the
ignition switch is in the ON or START
position.
The sunroof can also be operated for
about 3 minutes after the ...
