Hyundai Tucson: Windshield Wiper/Washer / Front Washer Motor

- Inspection Front and Rear Washer Motor

1.With the washer motor connected to the reservoir tank, fill the reservoir tank with water.

• Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.

2.Connect positive (-) battery cables to terminal 1 and negative (+) battery cables to terminal 2 respectively.

3.Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.If they are abnormal, replace the washer motor.

1.Disconnect the negative(-) battery terminal.

2.Drain the washer fluid less than 400 cc.

3.Check for continuity between the No. 1 and No.2 terminal in each float position.If the continuity is not as specified, replace the washer fluid level sensor

1.Disconnect the negative (-) battery terminal.

2.Remove the right front wheel guard.(Refer to Body - "Front Wheel Guard" )

3.Remove the washer hose and disconnect the washer motor connector.

4.Remove the washer motor.

5.Remove the washer reservoir (A) after loosening mounting bolts .

1.Check the filter for foreign material or contamination.

2.Install the washer reservoir.

3. Install the washer motor.

4.Connect the washer motor connector and washer hose.

5.Install the front wheel guard.