Hyundai Tucson: Front Door / Front Door Latch
1. Front door latch
1.Remove the front door module.(Refer to Front Door - "Front Door Module")
2.Remove the front door inside handle cage (A).
3.Separate the front door outside handle base connector and wiring harness (A).
4.Separate the front door inside handle cable (A) by pushing it in the direction of the arrow.
5.Remove the front door latch (A).
6.Disconnect the lock pin (A) in the direction of the arrow and then separate the connecting rod (B).
7.Press the lock pin, remove the front door outside handle base braket (A) from the front door latch (B).
8.To install, reverse removal procedure.
• Make sure the connector is connected properly.
• Make sure the door locks / unlocks and opens / closes properly.
• Replace any damaged clips (or pin-type retainers).
Front Door Side Weatherstrip
- Replacement
[Front door side weatherstrip]
1.Loosen the front door checker (B) mounting bolt.Tightening torque :16.7 - 21.6 N.m (1.7 - 2.2 kgf.m, 12.3 - 15.9 lb-ft)
2.Detach the clips, then re ...
Rear Door
...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Glove Box
- Component Location
1. Glove box
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Normal Maintenance Schedule
I : Inspect and if necessary, adjust, correct, clean or replace.
R : Replace or change.
*1 : Requires <API SN PLUS (or above) Full synthetic> grade engine oil. If a
lower grade engine oil (mineral type, semi-synthetic, lower
grade spec, etc.) is used, replace the engine oil and engine ...
