Hyundai Tucson: Braking System / Electronic Stability Control (ESC)
.png)
Electronic Stability Control helps stabilize the vehicle during cornering maneuvers.
ESC checks where you are steering and where the vehicle is actually going. ESC applies braking pressure to any one of the vehicle's brakes and intervenes in the engine management system to assist the driver with keeping the vehicle on the intended path. It is not a substitute for safe driving practices. Always adjust your speed and driving to the road conditions.
WARNING
Never drive too fast for the road conditions when cornering. ESC does not prevent a collision.
Excessive speed in turns, abrupt maneuvers, and hydroplaning on wet surfaces may result in severe collisions.
ESC operation
ESC ON condition
When the ignition switch is in the ON
position, ESC and the ESC OFF indicator
lights illuminate for about three seconds.
After both lights go off, ESC is enabled.
When operati ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Mass Air Flow Sensor (MAFS)
- Description
MAFS uses a hot-film type sensing element to measure the mass of intake
air entering the engine, and send the signal to ECM.A large amount of
intake air represents acceleration or high load conditions while a small
amount of intake air represents deceleration or idle. The ECM ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: If You Decide to Pull a Trailer
Consider using a sway control. You
can ask a trailer hitch dealer about
sway control.
Hyundai recommends that you do
not tow with your vehicle for the first
1,200 miles (2,000 km) to allow the
engine to properly break in.
Do not exceed 65 mph (104 km/h)
or the posted towing ...
