Hyundai Tucson: Warning and Indicator Lights / Downhill Brake Control (DBC) indicator light
This indicator light illuminates:
- When the ignition switch is in the ON position. The downhill brake control indicator light illuminates for about 3 seconds and then goes off.
- When you activate the system by pressing the DBC button.
This indicator light blinks:
When Downhill Brake Control system is operating.
This indicator light illuminates yellow:
Whenever there is a malfunction with Downhill Brake Control system, have the vehicle inspected by an authorized HYUNDAI dealer.
For more information, refer to the "Downhill Brake Control (DBC)" section in chapter 6.
Immobilizer indicator light
Without smart key
This indicator light illuminates:
When the vehicle detects the
immobilizer in the key with the
ignition switch in the ON position.
- At this time, you can start the
...
AUTO STOP indicator light. Turn signal indicator light
AUTO STOP indicator light
This indicator light illuminates:
When the engine enters the Idle Stop
mode of ISG (Idle Stop and Go) system.
When the engine automatically starts,
the AUTO STOP ind ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Rear Bumper Assembly
- Component Location
1. Rear bumper assembly
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Crankshaft Position Sensor (CKPS)
- Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If
there is no CKPS signal input, fuel is not supplied.That is, vehicle
can't run without CKPS signal. This sensor is installed on the cylin ...
