
1. Remote control switch (Audio swtich)
2. Remote control switch (Cruise control switch)

1.Check for resistance between terminals in right switch position.

| Switch | Connector terminal | Resistance (± 3%) |
| CANCEL | 2 ~ 6 | 610 Ω |
| SET (-) | 2 ~ 6 | 910 Ω |
| RES (+) | 2 ~ 6 | 1.38 kΩ |
| Cruise ON/OFF | 2 ~ 6 | 2.13 kΩ |
| Cruise & MSLA ON/OFF | 2 ~ 6 | 3.63 kΩ |
| Smart Cruise | 2 ~ 6 | 7.93 kΩ |
| Paddle shift (Down) | 1 ~ 7 | 390 Ω |
| Trip Group | 1 ~ 6 | 610 Ω |
| Trip Up | 1 ~ 6 | 910 kΩ |
| Trip Down | 1 ~ 6 | 1.38 kΩ |
| Trip OK | 1 ~ 6 | 2.13 kΩ |
| LFA | 1 ~ 6 | 7.93 kΩ |
1.Disconnect the negative (-) battery terminal.
2.Remove the steering wheel.(Refer to Steering System - "Steering Wheel")
3.Remove the paddle shift lever (A).

4.Disconnect paddle shift lever connector (A).

5.Remove the steering wheel cover (A) after loosening mounting screws.

6.Discoonect remote control switch connector (A) after loosening mounting screws.


7.Remove the remote control switch (A) after loosening mounting screws.

1.Install the remote control switch on the steering wheel.
2.Install the steering wheel lower cover.
3.Install the paddle shift lever.
4.Install the steering wheel.
5.Connect the negative (-) battery terminal.
• Make sure that the cables and connectors are plugged in properly.
• Check the AVN system for normal operation.
Schematic Diagrams
Rear View Monitor (RVM)Hyundai Tucson (NX4) 2022-2026 Service Manual: Overhead Console Lamp
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the overhead console cover (A).
3.Remove the mounting screws.and then remove the overhead console (A).
4.Remove the overhead console after disconnect the connector (A).
- Installation
1.Install the overhead console l ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Lane Keeping Assist Operation
Turning Lane Keeping Assist On/Off
With the ignition switch ON, press and
hold the Lane Driving Assist button
located on the steering wheel to turn
on and off. The white or green
indicator light illuminates on the
instrument cluster when the function is
on.
Press and hold the butt ...