Hyundai Tucson: Crash Pad / Cluster Fascia Panel
1. Cluster fascia panel
1. Cluster fascia panel
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Remove the crash pad garnish [LH].(Refer to Crash Pad - "Crash Pad Garnish")
2.Loosen the mounting screw, remove the cluster fascia panel (A).
3.To install, reverse the removal procedure.
• Replace any damaged clips (or pin-type retainers).
Components and Components Location
- Components
1. Crash pad side cover [LH]2. Crash pad lower panel3. Crash pad assembly4. Crash pad side cover [RH]
...
Crash Pad Garnish
- Component Location
1. Crash pad garnish [LH]2. Crash pad garnish [CTR]3. Crash pad garnish [RH]
- Replacement
• When removing with a flat-tip screwdriver or remov ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Front Washer Motor
- Inspection
Front and Rear Washer Motor
1.With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
• Before filling the reservoir tank with water, check the filter
for foreign material or contamination. if necessary, clean the filter.
...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Propeller Shaft Assembly. Propeller Shaft
Propeller Shaft
- Components
1. Front propeller shaft2. Center bearing bracket3. Rear propeller shaft
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister ...
