Hyundai Tucson: Lubrication System / Balance Shaft Module
• Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.(Refer to General Information - "Lift and Support Points")
1.Remove the oil pan.(Refer to the Lubrication System - "Oil Pan")
2.Remove the timing chain.(Refer to the Timing System - "Timing Chain")
3.Remove the oil pump.(Refer to the Lubrication System - "Oil Pump")
4.Remove the balance shaft assembly chain from the balance shaft assembly sprocket.
5.Remove the balance shaft assembly (A).
6.Install in the reverse order of removal.
• When assembling the balance shaft assembly, follow the below order.
(1)Assemble the balance shaft assembly mounting bolts as below order.
Tightening torque :29.4 N.m (3.0 kgf.m, 21.7 lb-ft)
2→6→1→4→3→5
(2)Loosen the balance shaft assembly mounting bolts as below order.5→3→4→1→6→2
(3)Assemble the balance shaft assembly mounting bolts as below order.
Tightening torque: 17.7 - 21.6 N.m + 58 - 62° (1.8 - 2.2 kgf.m + 58 - 62°, 13.0 - 15.9 lb-ft + 58 - 62°)
2→6→1→4→3→5
Oil Pump
- Removal
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.( ...
Oil Level Gauge & Pipe
- Removal and Installation
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Vehicle Load Limit
Two labels on your driver’s door sill show
how much weight your vehicle was
designed to carry: the Tire and Loading
Information Label and the Certification
Label.
Before loading your vehicle, familiarize
yourself with the following terms for
determining your vehicle’s weight
ratin ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: PTG Spindle
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the rear pillar trim.(Refer to Body (Interior and Exterior) - Interior Trim - Rear Pillar Trim)
3.Disconnect the PTG spindle connector (A).
4.Using a flat-tip screwdriver, remove the mounting clip (A).
5.Remove the spind ...
