Hyundai Tucson: Windshield Defrosting and Defogging / Automatic Climate Control System
To defog inside windshield
.png)
.png)
1. Select the desired fan speed.
2. Select the desired temperature.
3. Press the defrost button (.png)
).
4. The air conditioning turns on according to the detected ambient temperature, the outside (fresh) air position and higher fan speed are selected automatically.
If the air conditioning, outside (fresh) air position and higher fan speed are not selected automatically, adjust the corresponding button or knob.
If the defrost-level position is
selected, the fan speed increases.
To defrost outside windshield
.png)
.png)
1. Set fan speed to the highest position.
2. Set temperature to the extreme hot (HI) position.
3. Press the defrost button ().
The air conditioning turns on according
to the detected ambient temperature
and the outside (fresh) air position is
selected automatically.
If the defrost-level position is
selected, lower fan speed is adjusted to
higher fan speed.
Manual Climate Control System
To defog inside windshield
1. Select any fan speed.
2. Select the desired temperature.
3. Press the defrost button ().
4. The outside (fresh) air is selected
automatically. The air conditionin ...
Rear Window Defroster
NOTICE
Never use sharp instruments or window
cleaners containing abrasives to clean
the window to prevent damage to the
rear window defroster.
The defroster heats the
window to remove fros ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Remote key precautions
The remote key may not work if any of
the following occur:
The key is in the ignition switch.
The maximum operating distance limit
is exceeded (about 32 feet (10 m)).
The remote key battery is weak.
Other vehicles or objects may block
the signals.
The weather is extremely cold.
...
Hyundai Tucson (NX4) 2022-2026 Service Manual: General Tightening Torque Table. General Information
General Information
- Tightening Torque Table of Standard Parts
BOLT (Nominal diameter)NUT (Nominal diameter)
BOLT/ NUT Normal screw Torque Nm (kg.m, Ib-ft)
Nominal diameter.(mm)Pitch [mm (in.) ]4T8T10T
M50.8 (0.031) 2.0 - 3.0 (0.2 - 0.3, 1.4 - 2.2) 4.9 - 6.9 (0.5 - 0.7, 3.6 - 5. ...
