| Symptom | Probable cause | Remedy |
| Play in steering | Loose yoke plug | Retighten |
| Loose steering gear mounting bolts | Retighten | |
| Loose or worn tie rod end | Retighten or replace as necessary | |
| Steering wheel does not return properly | Excessive turning resistance of tie rod end | Replace |
| Yoke plug excessively tight | Adjust | |
| Tie rod and/or ball joint cannot turn smoothly | Replace | |
| Loose mounting of gear box mounting bracket Worn steering shaft joint and/or | Retighten | |
| Worn steering shaft joint and / or body grommet | Correct or replace | |
| Distorted rack | Replace | |
| Damaged pinion bearing | Replace | |
| Twisted or damaged hoses | Reposition or replace | |
| Damaged oil pressure control valve | Replace | |
| Damaged oil pump input shaft bearing | Replace | |
| Rattling or chucking noise in the rack and pinion | Interference with hoses from vehicle body | Reposition |
| Loose gear box bracket | Retighten | |
| Loose tie rod end and / or ball joint | Retighten | |
| Worn tie rod and / or ball joint | Replace |
Steering System
SpecificationsHyundai Tucson (NX4) 2022-2026 Service Manual: Oil Filter & Oil Cooler
- Removal and Installation
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.(Refer to General Information - "Lift and
Support Points")
1.Remove the engine r ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rail Pressure Sensor (RPS)
- Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and
measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in the sensor converts the
pressure to voltage signal. By using this signal, the ECM can control
...