Hyundai Tucson: Tire Pressure Monitoring System (TPMS) / TPMS Malfunction Indicator
.png)
The TPMS Malfunction Indicator illuminates after it blinks for about one minute when there is a problem with the Tire Pressure Monitoring System.
Have the system inspected by an authorized HYUNDAI dealer as soon as possible.
NOTICE
If there is a malfunction with the TPMS, the individual tire pressures on the cluster display are not be available. Have the system inspected by an authorized HYUNDAI dealer as soon as possible.
NOTICE
The TPMS Malfunction Indicator may illuminate after blinking for one minute if the vehicle is near electric power supply cables or radio transmitters such as police stations, government and public offices, broadcasting stations, military installations, airports, transmitting towers, etc.
Additionally, the TPMS Malfunction Indicator may illuminate if snow chains are used or if electronic devices such as computers, chargers, remote starters, navigation, etc. are near the vehicle. This may interfere with normal operation of the TPMS.
Low Tire Pressure Position and
Tire Pressure Telltale
TMPS is not a substitute for manually
checking the tire pressure with a tire
gauge. Changes in temperature affect
tire pressure. Refer to "Check tire
inflation pressure" in the Maintenance
...
Changing a Tire with TPMS
If you have a flat tire, the Low Tire
Pressure and Position telltales come
on. Have the flat tire repaired by an
authorized HYUNDAI dealer as soon as
possible or replace the flat tire with the ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Refrigerant System Service Basics (R-134a)
Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air
conditioning system.
• Air conditioning refrigerant or lubrican ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Power Door Mirror Actuator
- Removal
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Disconnect (-) battery terminal.
2.Using a fastener remover (C), remove the mirror ...
