Hyundai Tucson: Surround View Monitor (SVM) / Surround View Monitor Operation
Parking/View button
.png)
Press the Parking/View button 1 to turn on Surround View Monitor.
Press the button again to turn off the function.
Front view
.png)
The front view appears on the screen when the gear is in N (Neutral) or D (Drive) to assist parking. The front view has top view, front view, and side view.
View modes can be selected by pressing the view buttons 2 on the Surround View Monitor screen.
Turns on if:
- You shift the gear from R (Reverse) to N (Neutral) or D (Drive), and your vehicle speed is below 9 mph (15 km/h).
- You press the Parking/View button 1 when the gear is in N (Neutral) or D (Drive) and your vehicle speed is below 9 mph (15 km/h).
- The Parking Distance Warning warns you while driving in D (Drive). (Surround View Monitor Auto On must be selected from the Settings menu.)
Information
When the front view is turned on, the last view mode appears.
Turns off if:
- You press the Parking/View button 1 or the infotainment system buttons 3.
- Your vehicle speed is above 9 mph (15 km/h).
- You shift the gear to P (Park).
Information
Surround View Monitor turns off if your vehicle speed is greater than 9 mph (15 km/h). Although you slow down to less than 9 mph (15 km/h) again, Surround View Monitor does not turn on again.
Rear view
The rear view appears on the screen when the gear is in R (Reverse) or P (Park) to assist parking. The rear view has top view, front view, and side view. View modes can be selected by pressing the view buttons 2 on the Surround View Monitor screen.
Turns on if:
- You shift the gear to R (Reverse).
- You press the Parking/View button 1 while the gear is in P (Park).
Turns off if:
- You press the Parking/View button 1 again while the gear is in P (Park).
- You shift the gear from R (Reverse) to P (Park).
Information
The rear view cannot be turned off
when the gear is in R (Reverse) even if
the infotainment system buttons Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Cluster Display Message
(Button type)
Camera settings
To change the settings of Surround View
Monitor's Display Contents or Display
Settings, press the setup icon ()
on
the screen while Rear View Monitor is
operating, or go t ...
Surround View Monitor Settings
Surround View Monitor malfunction
When Surround View Monitor is not
working properly, or the screen flickers,
or the camera image does not display
normally, have the vehicle inspected by
an a ...
Surround View Monitor
Malfunction and LimitationsOther information:
- Compression Pressure Inspection
• If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.Start the engine until coolant temperature goes up to 80-95°C and stop the engine.
2.Remove the spark coils.(Refer to E ...
Information
The actual message may differ from
the following cluster display message.
The following messages may differ
depending on the vehicle model.
Shifting conditions not met. Reduce
speed, then shift
This message appears when the engine
RPM is too high or when driving too f ...
