Inspect ignition coil assembly and Perform spark test
1.Check for DTCs.
• If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide)
2.Check if sparks occur. â– Without diagnostic tool
(1)Remove the engine cover.(Refer to Engine Mechanical System - "Engine Cover")
(2)Remove the ignition coils.(Refer to Ignition System - "Ignition Coil")
(3)Using a spark plug wrench, remove the spark plugs.(Refer to Ignition System - "Spark Plug")
(4)Connect the connector after install the spark plug to ignition coil.
(5) Ground the spark plug to the engine.

(6)Check if sparks occur at each spark plug while engine is being cranked.
• Do not crank the engine for more then 5 seconds.
â– With diagnostic tool(1)Remove the engine cover.(Refer to Engine Mechanical System - "Engine Cover")
(2)Remove the ignition coils.(Refer to Ignition System - "Ignition Coil")
(3)Using a spark plug wrench, remove the spark plugs.(Refer to Ignition System - "Spark Plug")
(4)Connect the diagnostic tool to data link connector (DLC).
(5)Turn the ignition switch ON.
(6)Select "Vehicle, Model year, Engine, System".
(7)Select "Actuation Test".
(8)Select "Ignition Coil Enable/Disable-#1, #2, #3, #4".


• Do not crank the engine for more then 5 seconds.
3. If sparks do not occur, perform the following test.

4.Using a spark plug wrench, install spark plugs.(Refer to Ignition System - "Spark Plug")
5.Install the ignition coils.(Refer to Ignition System - "Ignition Coil")
6.Install the engine cover.(Refer to Engine Mechanical System - "Engine Cover")
Schematic Diagrams
Ignition CoilHyundai Tucson (NX4) 2022-2026 Owner's Manual: SRS Care
The SRS is virtually maintenance-free
and there are no parts you can safely
service by yourself. If the SRS airbag
warning light does not illuminate when
the ignition switch is in the ON position
or continuously remains on, have the
system immediately inspected by an
authorized HYUNDAI ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Mass Air Flow Sensor (MAFS)
- Description
MAFS uses a hot-film type sensing element to measure the mass of intake
air entering the engine, and send the signal to ECM.A large amount of
intake air represents acceleration or high load conditions while a small
amount of intake air represents deceleration or idle. The ECM ...