Hyundai Tucson: Engine Mechanical System / Special Service Tools
| Tool (Number and name) | Illustration | Use |
| Crankshaft front oil seal installer 09214-L1100 Handle 09231-H1100 |
| Installation of the crankshaft front oil seal |
| Valve stem seal installer 09222-4A000 |
| Installation of the valve steam seal |
| Valve spring compressor 09222-3K000 Valve spring compressor adapter 09222-3K100 |
| Removal and installation of the intake or exhaust valve spring & retainer lock |
| Crankshaft rear oil seal installer 09214-L1200 Handle 09231-H1100 |
| Installation of crankshaft rear oil seal |
| Ring gear stopper 09231-2B100 |
| Removal and installation of crankshaft damper pulley bolt |
| Ring gear stopper 09231-3D100 |
| "Removal and installation of crankshaft damper pulley bolt" |
| Oil pen remover 09215-3C000 |
| Removal of oil pen |
| A: E-CVVT plug installer B: E-CVVT cover installer C : Handle 09243-C2000 |
| Installation of E-CVVT assembly plug Installation of E-CVVT cover |
| Water pump belt remover & installer 09252-C1000 |
| Removal and installation of water pump belt |
| Pressure cap pressure checker 0K253-P4200 |
| Used for checking for pressure cap pressure and a coolant leak |
Specifications
- Specifications
DescriptionSpecificationsLimit
General
TypeIn-line, DOHC　
Number of cylinders4　
Bore88.5 mm (3.484 in.)　
Stroke101.5 mm (3.996 in.)　
Total displacement2497 cc (152.38 ...
Repair procedures
- Compression Pressure Inspection
• If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.Start the engine until ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Electro Chromic Inside Rear View Mirror
Description and Operation
- Description
Electro Chromic Inside Rear View Mirror
The ECM (Electro Chromatic inside rear view Mirror) is intended dim the
reflecting light in the rear view mirror. The forward facing sensor
detects brightness of the surroundings, while the rearward looking
se ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Electronic Oil Pump (EOP)
- Removal
1.Turn ignition switch OFF and disconnect the battery negative (-) terminal
2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")
3.Disconnect the electronic oil pump connector (A).
4.Remove the electronic oil pump (A) after removing ...
