Hyundai Tucson: ISG (Idle Stop & Go) System / Schematic Diagrams
• The ISG system is strongly networked with the power management.
• In the event of battery replacement, disconnection of the battery terminal or after changing the engine management system, the reference data regarding the battery charge state and battery condition can be lost.
• They are only available again a closed-circuit current measurement of approximate 4 hours in which the vehicle may not be wakened. In this time, the ISG system is inactive.
Description and Operation
- Description
Idle Stop & Go (ISG) system switches off the ignition when vehicle
is stopped, and then restarts the ignition and starts the vehicle when
accelerator is pushed. It temporarily ...
Repair procedures
- Operating Condition for the ISG function
1. Auto stop or Auto start condition
â–¶ If all of the below conditions are satisfied
• If the following conditions are not met, ent ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Changing a Tire with TPMS
If you have a flat tire, the Low Tire
Pressure and Position telltales come
on. Have the flat tire repaired by an
authorized HYUNDAI dealer as soon as
possible or replace the flat tire with the
spare tire.
NOTICE
Do not use a puncture-repair kit not
approved by HYUNDAI. Tire sealant not ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Accelerator Position Sensor (APS)
- Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS
is one of the most important sensors in engine control system, so it
consists of the two sensors which adapt individual sensor power ...
