Hyundai Tucson: Rear Suspension System / Rear Stabilizer Bar

- Removal

• When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister).(Refer to General Information - "Lift and Support Points")

1.Raise the vehicle, and make sure it is securely supported.

2.In the case of 4WD vehicle, remove the rear differential assembly.(Refer to Driveshaft and axle - "Rear Differential Carrier")

3.Remove the rear stabilizer link after loosening the mounting nut (A).

Tightening torque : 49.0 - 58.8 N.m (5.0 - 6.0 kgf.m, 36.2 - 43.4 lb-ft)

4.Remove the rear stabilizer bar (A) after loosening the mounting bolts.

Tightening torque :53.9 - 63.7 N.m (5.5 - 6.5 kgf.m, 39.8 - 47.0 lb-ft)

1.Check the rear stabilizer bar for deformation.

2.Check the rear stabilizer link ball joint for damage.

1.To install, reverse the removal procedures.

2.Check the alignment.(Refer to Suspension System - "Alingment")