Hyundai Tucson: Rear Glass Defogger / Rear Glass Defogger Switch
1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (diagnostic tool).The diagnostic system (diagnostic tool) provides the following information.
(1)Fault Code Searching : Checking failure and code number (DTC)
(2)Data Analysis : Checking the system input/output data state
(3)Actuation test : Checking the system operation condition
(4)S/W Management : Controlling other features including system option setting and zero point adjustment
2.If diagnose the vehicle by diagnostic tool, select "DTC Analysis" and "Vehicle".
3.Select the 'Data Analysis' and 'Car model'.
4.Select the 'IBU_BCM' to search the current state of the input/output data.
5.To forcibly actuate the input value of the module to be checked, select option 'Actuation Test'.
1.isconnect the negative (-) battery terminal.
2.Remove the heater and A/C controll unit.(Refer to Heating,Ventilation, Air Conditioning - "Heater & A/C Control Unit (Manual)")(Refer to Heating, Ventilation, Air conditioning - "Heater & A/C Control Unit (DATC)")
1.Install the heater and A/C control unit.
2.Connect the negative (-) battery terminal.
Rear Glass Defogger Printed Heater
- Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure on the tin foil, moving
the tin foil along the ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Purge Control Solenoid Valve (PCSV)
- Description
Purge Control Solenoid Valve (PCSV) is a solenoid valve and is
installed on the surge tank and controls the passage between the
canister and the intake manifold.The evaporative gases gathered in the
canister are delivered to the intake manifold when the PCSV is open by
ECM c ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Front Glass
- Removal
• In order to remove the front glass, use the tools shown in the following figure:[Tooling Diagram]
① Square wire② Insert-type wire grip[Tooling Assembly Diagram]
• Insert and affix square wire ① into the insert hole of the wire grip ②.
1.Press pa ...
