Rear Cross-Traffic Safety
.png)
With the ignition switch ON, go to User Settings > Driver Assistance > Parking Safety > Rear Cross-Traffic Safety (for cluster type) or Setup > Vehicle > Driver Assistance > Parking Safety > Rear Cross-Traffic Safety (for infotainment system type) from the Settings menu to turn Rear Cross-Traffic Collision Warning on and off.
WARNING
When the engine is restarted, the Rear Cross-Traffic Collision Warning turns on. If Off is selected after the engine is restarted, Rear Cross-Traffic Collision Warning does function until the next time the vehicle is started.
Information
You can change the Warning Timing and Warning Volume settings for Rear Cross-Traffic Collision Warning from the Settings menu. For more information, refer to the "Driver Assistance System Settings" section in this chapter.
Rear Cross-Traffic Collision Warning (RCCW)
Rear Cross-Traffic Collision
Warning OperationHyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Operating Condition for the ISG function
1. Auto stop or Auto start condition
â–¶ If all of the below conditions are satisfied
• If the following conditions are not met, entry into the ISG system is prohibited.
ComponentConditionsRemark
ATMT
ISG OFF SwitchOFFOFFISG OF ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Schematic Diagrams
- Circuit Diagram
Connector Pin Information
Pin NOWiring Harness ConnectorPanorama MotorBlind Motor
1Ground 1Ground 1Ground 2
2---
3Power Window Enable Power Window Enable -
4Tilt Up SwitchTilt Up Switch-
5Open SwitchOpen Switch-
6Battery 1 (+)Battery 1 (+)Battery 2 (+)
7LINLINLIN ...