Hyundai Tucson: Front Seat / Front Seat Assembly
1. Front seat assembly
1.Disconnect the negative (-) battery terminal.
2.Open the cover and loosen the front seat mounting bolts.
Tightening torque: 49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)
Tightening torque: 49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)
3.Disconnect the main connector (A) , side airbag connector (B) , front seat belt buckle connector (C) and OCS connector (D).
4.To install, reverse removal procedure.
• Push the seat to the rear end of slides and initially tighten the front mounting bolts.
• Push the seat to the front end of slides and completely tighten the rear mounting bolts.
• Send the seat to the rear end again to completely tighten the front mounting bolts.
• Check the seat for smooth movement.
• For the non-automatic slide seats, check the seats are fixed at each designated fixing position.
Front Seat
...
Front Seat Shiled Outer Cover
- Component Location
1. Front seat shield outer cover
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Smart Cruise Control display
The status of the Smart Cruise Control
operation appears in Driving Assist mode
on the instrument cluster. Refer to the
"View Modes" section in Chapter 4.
When operating
1 Whether there is a vehicle ahead and
the selected distance level appears.
2 Set speed appears.
3 Whether there i ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Front Monitor
- Components
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the front monitor lower cover (A).
3.Remove the front monitor lower cover after disconnecting the mood lamp connector (A).
4.Remove front monitor side cover (A) and (B).
5.Remove the front mon ...
