Hyundai Tucson: Lubrication System / Oil Level Sensor
1.Remove the engine room under cover.(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.Drain the engine oil.(Refer to Lubrication System - "Engine Oil")
3.Disconnect the oil level sensor connector.
4.Remove the oil level sensor (A).
Tightening torque :8.8 - 9.8 N·m (0.9 - 1.0 kgf·m, 6.5 - 7.2 lb·ft)
• Always use new gasket.
5.Install in the reverse order of removal.
Oil Pressure Control Solenoid Valve
- Removal and Installation
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Fuel Pressure Test
- Fuel Pressure Test
1.Release the residual pressure in fuel line.(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
• When removing the fuel pump relay, the Diagnostic Trouble Code
(DTC) will be occurred. Therefore delete the code with the diagnosti ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Door Garnish
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Loosen the mounting nuts, remove the front door garnish (A) and rear door garnish ...
