Hyundai Tucson: Lane Keeping Asiist {LKA} / Lane Keeping Assist Settings
Lane Safety
.png)
With the ignition switch ON, go to User Settings > Driver Assistance > Lane Safety (for cluster type) or Setup > Vehicle > Driver Assistance > Lane Safety (for infotainment system type) from the Settings menu to select the following:
- If Assist is selected, Lane Keeping Assist sounds an audible warning, and assists with steering your vehicle to help prevent your vehicle from departing its travel lane.
- If Warning Only is selected, Lane Keeping Assist sounds an audible warning. The function does NOT steer your vehicle if a lane departure is detected.
- If Off is selected, Lane Keeping Assist
turns off. The
.png)
indicator light
turns off on the instrument cluster.
WARNING
- If Warning Only or Off is selected, Lane Keeping Assist does not steer if a lane departure is detected.
- Lane Keeping Assist does not assist with steering if you drive near the middle of the lane.
Information
You can change the Warning Volume settings or select Driving Safety Priority for Lane Keeping Assist from the Settings menu. For more information, refer to the "Driver Assistance System Settings" section in this chapter.
Lane Keeping Asiist {LKA}
Lane Keeping Assist uses the front view
camera to help detect lane markings
(or road edges) while driving over a
certain speed. Lane Keeping Assist may
warn you if your vehicle leaves the lane ...
Lane Keeping Assist Operation
Turning Lane Keeping Assist On/Off
With the ignition switch ON, press and
hold the Lane Driving Assist button
located on the steering wheel to turn
on and off. The white or green
indicat ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Brake Fluid
Checking the Brake Fluid Level
Check the fluid level in the reservoir
periodically. The fluid level must be
between the MAX and the MIN marks on
the side of the reservoir.
Before removing the reservoir cap and
adding brake fluid, clean the area around
the reservoir cap thoroughly to pr ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Dynamic Damper
- Removal
1.Remove the front drive shaft.(Refer to Driveshaft Assembly - "Front Driveshaft")
2.Remove the trans axle side joint.(Refer to Driveshaft Assembly - "Transaxle Joint")
3.Remove the dynamic damper band (A, B) using driver (-).
• When removing the dynamic d ...
