Hyundai Tucson: Engine And Transaxle Assembly / Engine Room Under Cover
• Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.(Refer to General Information - "Lift and Support Points")
1.Remove the engine room under cover (A).
Tightening torque :Bolt : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
2.Installation is reverse order of removal.
1.Remove the engine room rear under cover (A).
Tightening torque :Bolt : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
Engine Cover
- Removal and Installation
1.Remove the engine cover (A).
• Remove the engine cover on room temperature.
• Do not disengage both front and rear mounting point at the sa ...
Engine Mounting
- Components
1. Engine mounting support bracket2. Engine mounting bracket3. Transaxle mounting bracket4. Roll road bracket
- Removal and Installation
• Be careful no ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Windows. Power Windows
1 Driver’s door power window switch
2 Front passenger’s door power window
switch
3 Rear door (left) power window switch
4 Rear door (right) power window switch
5 Window opening and closing
6 Automatic power window
(if equipped)
7 Power window lock button
Power Windows
The ignit ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Door Inside Handle
- Replacement
1.Disconnect the negative ( - ) battery terminal.
2.Remove the rear door trim.(Refer to Rear Door - "Rear Door Trim")
3.Loosen the mounting screws and remove the rear door inside handle (A).
4.To install, reverse removal procedure.
• Make sure the door lo ...
