Hyundai Tucson (NX4) 2022-2026 Service Manual / Brake System / ESC (Electronic Stability Control) System / Downhill Brake Control Swtich

Hyundai Tucson: ESC (Electronic Stability Control) System / Downhill Brake Control Swtich

- Description The DBC function is the acronym word of Downhill Brake Control function. When a vehicle goes down the hill, just pushing the DBC switch enables the car to keep its vehicle's speed at a constant value without operating the brake pedal. The DBC function is operat]ed when the vehicle is on the decline and its velocity is under the predetermined speed. - Removal

1.Disconnect the battery negative ( - ) terminal.

2.Remove the floor console upper cover.(Refer to Body - "Floor Console Assembly")

3.Disconnect the floor console upper cover switch connector (A).

4.Remove the screws and remove the floor console upper cover switch (A).

- Installation

1.Install in the reverse order of removal.

Rear Wheel Speed Sensor

- Components [2WD] 1. Rear wheel speed sensor [4WD] 1. Rear wheel speed sensor - Removal • Be careful not to damage the parts located under the vehicle (flo ...

Body (Interior and Exterior)

...

Other information:

Hyundai Tucson (NX4) 2022-2026 Service Manual: Trailing Arm
- Removal • When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister).(Refer to General Information - "Lift and Support Points") 1.Loosen the rear wheel nuts slightly.Raise the v ...

Hyundai Tucson (NX4) 2022-2026 Service Manual: Front Pillar Trim
- Component Location 1. Front pillar trim - Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Put on gloves to prevent hand injuries. • Take ca ...