Hyundai Tucson: Interior Trim / Door Scuff Trim
1. Front door scuff trim
2. Rear door scuff trim
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Remove the front door body side weatherstrip.(Refer to Front Door - "Front Door Side Weatherstrip")
2.Using a screwdriver or remover and remove the front door scuff trim (A).
3.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Remove the rear door body side weatherstrip.(Refer to Rear Door - "Rear Door Side Weatherstrip")
2.Remove the rear seat assembly.(Refer to Rear Seat -"Rear Seat Assembly")
3.Using a screwdriver and remove the rear door scuff trim (A).
4.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
Components and Components Location
- Components
1. Cowl side trim [LH]2. Cowl side trim [RH]3. Front pillar trim4. Center pillar upper trim5. Front door scuff trim6. Center pillar lower trim7. Rear door scuff trim8. Rear pillar t ...
Door Step Trim
- Component Location
1. Front door step trim2. Rear door step trim
- Replacement
• When prying with a flat-tip screwdriver, wrap it with protective
tape, and appl ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Glass Defogger Switch
- Inspection
Diagnosis with diagnostic tool
1.In the body electrical system, failure can be quickly diagnosed by
using the vehicle diagnostic system (diagnostic tool).The diagnostic
system (diagnostic tool) provides the following information.(1)Fault Code Searching : Checking failure and cod ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Heater Core
- Replacement
1.Disconnect the negative (-) battery terminal.
2.Remove the heater and blower assembly.(Refer to Heater - "Heater Unit")
3.Loosen the mounting screws and remove the heater core cover (A).
4.Separate the heater core (A) from the heater unit.
5.Install in the reverse ord ...
