Hyundai Tucson Owners & Service Manuals

Hyundai Tucson: Brake System / Brake Pedal

- Components

1. Brake member assembly
2. Stop lamp switch
3. Brake pedal arm assembly
4. Brake pedal pad


- Removal

1.Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")

3.Disconnect the stop lamp switch connector (A).

4.Remove the brake pedal arm split pin (B) and the clevis pin (A).

5.Loosen the nuts (A, B) and then remove the brake pedal assembly.

Tightening torque :16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)

- Inspection

1.Check the brake pedal for bending or twisting.

2.Check the brake pedal return spring for damage.

3.Check the stop lamp switch.(Refer to Brake System - "Stop Lamp Switch")

- Installation

1.Installation is the reverse of removal.

   

• When installing the clevis pin, apply the grease.

• Use a new snap pin whenever installing.

    Brake oil
    - Specification Fluid Type DOT 4 Reservoir Quantity (cc) TOTAL VOLUME A + B + C + D + E + F410 ± 20 MAX LEVELA + B + C + D + E396 ± 20 ON LEVELB + C + D + E128 ± 20 MIN LEVELC + D + E ...

    Front Brake Caliper
    - Components 1. Caliper body2. Caliper carrier3. Pad inner shim4. Pad retainer5. Brake pad - Removal     • Be careful not to damage the parts located under the vehicle ...

    Other information:

    Hyundai Tucson (NX4) 2022-2026 Service Manual: Manifold Absolute Pressure Sensor (MAPS)
    - Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calculates the intak ...

    Hyundai Tucson (NX4) 2022-2026 Service Manual: 4WD Control System
    - Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the coupling.Compensation Requirement and Procedure 1.Simultaneous replacement of 4WD ECU ...

    © 2023-2026 Copyright www.htucson4.com