Hyundai Tucson: Starting System / Starter Relay
1.Turn ignition switch OFF and disconnect the battery negative (-) terminal.
2.Remove the fuse box cover.
3.Remove the starter relay (A).
4.Check for continuity between the terminals (30 and 87) using an ohmmeter.
| Terminal | Resistance | Measure | ||
| 30 - 87 | 1 MΩ or higher | If there is continuity between the terminals, replace the relay. | ||
5.Apply 12V to the terminal 85 and ground to the terminal 86 and then check for continuity between the terminals (30 and 87).
| Terminal | Resistance | Measure | ||
| 30 - 87 | 1Ω or less | If there is no continuity between the terminals, replace the relay. | ||
6.Install the starter relay.
7. Install the fuse box cover.
Starter
- Description
The starting system includes the battery, starter, solenoid switch,
ignition switch, ignition lock switch, connection wires and the battery
cable.When the ignition key is turned t ...
Ignition System
...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Removal
• Put on gloves to prevent hand injuries.
• Use seat covers to avoid damaging any surfaces.
1.Remove the liftgate trim.(Refer to Liftgate - "Liftgate Trim")
2.Remove the rear spoiler.(Refer to Body Side Molding - "Rear Spoiler")
3.Dis ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Water Jacket Insert
- Removal and installation
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.(Refer to General Information - "Lift and
Support Points")
1.Remove the cylinder ...
