
1.Disconnect the negative (-) battery terminal.
2.Remove the cluster fascia panel.(Refer to Body - "Cluster Fascia Panel")
3.Remove the front monitor.(Refer to AVN System - "Front Monitor")
4.Using a remover and remove the crash pad garnish [CTR].

5.Disconnect the start / stop button connector (A).

6.Loosen the mounting screws and remove the start / stop button (A).

1.Install the start / stop button.
2.Install the crash pad garnish [CTR].
3.Install the front monitor.
4.Install the cluster fascia panel.
Components and Components LocationHyundai Tucson (NX4) 2022-2026 Owner's Manual: Icy road warning light
This indicator light illuminates:
To warn the driver the road may be icy.
When the outside temperature on the
temperature gauge is below 40 °F (4
°C), a single chime sounds, both the
outside temperature gauge and Icy Road
Warning indicator blink several times,
and then they remain il ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Coil Spring
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister).(Refer to General Information - "Lift and Support
Points")
1.Loosen the rear wheel nuts slightly.Raise the v ...