Hyundai Tucson: Horn / Repair procedures
1.Remove the front bumper assembly.(Refer to Body - "Front Bumper Assembly")
2.Remove the bolts and disconnect the horn connectors (C), then remove the high pitch horn (B) and low pitch horn (A).
1.Install the horns after connecting the horn connectors.
2.Install the front bumper cover.
1.Remove the horn relay (A) from the engine room relay box.
2.There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
3.There should be no continuity between the No.30 and No.87 terminals when power is disconnected.
Components and Components Location
- Component Location
1. Horn switch2. Horn relay 3. Horn (Low pitch)4. Horn (High pitch)5. Clock spring
...
AVN System
...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Rear Transverse Trim
- Component Location
1. Rear transverse trim
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Piston and Connecting Rod
- Removal
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.(Refer to General Information - "Lift and
Support Points")
• Use fender cov ...
