Hyundai Tucson: Floor Carpet / Repair procedures
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Remove the floor console assembly.(Refer to Floor Console - "Floor Console Assembly")
2.Remove the front seat assembly.(Refer to Front Seat - "Front Seat Assembly")
3.Remove the rear seat cushion assembly.(Refer to Rear Seat - "Rear Seat Assembly")
4.Remove the cowl side trim.(Refer to Interior Trim - "Cowl Side Trim")
5.Remove the center pillar lower trim.(Refer to Interior Trim - "Center Pillar Trim")
6.Remove the luggage side trim.(Refer to Trunk Trim - "Luggage Side Trim")
7.Remove the accelerator pedal module.(Refer to Fuel system - "accelerator pedal")
8.Remove the front floor carpet (A).
9.Remove the rear floor carpet (B).
10.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
1. Rear floor carpet
2. Front floor carpet
3. Rear tunnel pad
4. Front tunnel pad
Floor Carpet
...
Front Bumper
...
Other information:
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Tire Sidewall Labeling
This information identifies and
describes the fundamental
characteristics of the tire and also
provides the tire identification
number (TIN) for safety standard
certification. The TIN can be used to
identify the tire in case of a recall.
1. Manufacturer or brand name
Manufacturer or ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Ignition Switch
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the steering column upper and lower shrouds.(Refer to Body - "Steering Column Shroud Panel")
3.Remove the ignition switch (A) after disconnecting the 6P connector (B).
4.Remove the key warning and immobilizer connector (A). ...
